-
John and Alyson Blashkiw Changed their profile cover
Be the first to like this!no comments -
David & Grace Rogers replied to the topic Broom 37 head linings in the forum Technical
Hi Stephen, I believe that the headlining in our 10/70 in the aft cabin is secured by staples around the edges and those staples are then concealed by a stick on trim about 18mm wide. Seem to remember that there was a Broom owner on this site who asked the same question a while back as he wanted to get to the nuts securing an aft bollard to remove…Read More
Be the first to like this!no comments -
David, Colin and Geraldine Morrison replied to the topic Broom 37 head linings in the forum Technical
I also have a Broom Ocean 37 and would like to see an answer to your question
Secondly and I feel foolish asking but what is the voice in “0 replies, 1 voice”
Be the first to like this!no comments -
Michael & Gaynor Herlihy replied to the topic Ocean 38 Radar Arch Gas Struts in the forum Technical
Hello John.
Sorry, only just picked this up. There is no extra reinforcement behind the fixing brackets as far as I can see. The fibreglass is pretty thick there anyway so I assume it’s not needed.
Yes there are two struts, one each side. Each one 1500N as in my photo on page 1 of the tread.
Hope this helps.Mike
Be the first to like this!no comments -
Nigel and Diane Hills replied to the topic Broom 30 shaft bearing in the forum Technical
Hi Chris,
Are you refering to the shart support bearing,commonly known as the plummer block or pillar bearing?
This pic is the one is fitted to my Broom 32. So simplistic in design. After removing top-section there is a split white metal shells with a splash ring that lubricates the shell bearings. Recommended oil is 20-50w non sythetic.
The…Read More
Be the first to like this!no comments - Load More Posts